Swapping the Slider's End Plate
Updated
If you're swapping between rails or replacing a broken or damaged end plate, below is a video showing how quick and simple it is.
You may need to replace the end plate if:
- You have an EVO slider and are using the High Torque motor.
- the updated end plate has a press fit pulley, which is stronger and allows it to handle the torque of the motor.
- The drive shaft (silver square) is damaged.
- This can happen if the flywheel is left connected during transport or it gets bumped abruptly or the motor is installed incorrectly.
End plates can be purchased here.
If you have any questions reach out to support@rhinocg.com
